Print
Parent Category: NATURAL LIVING
Category: Brewing

 

You have gone through the entire process now, and finally, after just about an entire week, you have beer. Actual beer, it will make you drunk just like Charley’s Palace brew, and if you worked cleanly and hygienically, it will actually taste cleaner, cause less hangover, and should not cause any health problems associated with infected beer such as Charley’s. It is, however, not exactly classy. If you were lucky and diligent, it should be more or less clear with minimal sediment. It will, however, be almost totally flat. Fear not, we fix that chop-chop.

 

First, we line up enough empty, clean and sterilised bottles for our beer. How many bottles? That depends on how much beer you have, divided by the LITRE capacity of your bottles. Eighteen litres and 330ml bottles means 18/0,33 = 55 dumpies. Because of sedimentation, we’d rather use 36 bottles of 500ml, or our favourite, 660ml bottles, and we usually fill around two crates and four spares. Two for the museum, and two for sampling when we lose patience waiting. That leaves one case for each of us two brewing buddies. As a final precaution, we use a small steam cleaner with a longer nozzle that fits right to the bottom of our bottles. This is how it goes:

 

Line up six empty bottles. Get the steamer (and everything else) lined up.

 

Put enough new crowns, plus a few spares for fumbling loss, into a bowl of boiling water.

 

Sterilise some honey. We gladly endorse Goldcrest, they are clean, pure, not irradiated. Mix 10ml per liter of beer, with equal amount boiling water in a sterilised cup. Prepare a clean, sterile syringe, the bigger the better. Mark it in 6ml steps for 660ml bottles, more or less, and just to confuse the issue, 10ml honey + 10ml water is not 20ml syrup. It’s a lot less! Stick to six mil, it is safe. Exploded beer tastes like failure and dust. Keep the marked syringe by the honey.

 

Put your fermenter where it is easy to work cleanly, like the kitchen table top. On the one side of the fermenter, must be space to work with the honey and six bottles. On the other side, place to work with one bottle, the bowl of crown caps, and the bottle capper. You want a sturdy table, that you can work on with some force in your arms. Capping the bottles can be difficult if you are too short, tall or uneven in your arrangements for this. Expect to waste some caps and bottles (with their contents) before you master this particular job. Save some money, and cap some water first. NOT ALL BOTTLES ARE REUSABLE. Not all bottles can be sealed using the normally available crimpers.

 

Right, now the dance starts:

Grab bottle, turn upside down, blast out with steam. Hand over.

Pump syringe 6ml honey syrup into bottle. Hand over

Open fermenter tap when drain pipe is at bottom of bottle to prevent splashing. Fill, hand over.

Take cap from hot tub, set on bottle, crimp. Put into crate.

 

Repeat above until the fermenter starts running yeast instead of beer.If it was a good brew, this yeast may be IMMEDIATELY REUSED. Look out for infections!

 

Honey dissolves water, so no stirring is needed for the beer once bottled. Age appropriately.

 

This is how to do the secondary fermentation and ageing and presentation al in one step. You end up with a clean, frothy, bubbly beer in a bottle, best enjoyed from a glass. Different beers actually taste different in differently shaped glasses. See this link for info on PROPER BEER GLASSES. The traditional German mug with the flare at the bottom is a very good compromise, especially if your beer is still a bit murky.